Kitchen - Tips and Tricks

 Everybody likes a nice kitchen! Not only do we want it to look nice and clean, but we want it to be as efficient and functional as possible. We thought a few tips and ideas on how to get the most use out of a kitchen as possible would be a good addition to our arsenal of information. We hope you can find the following information useful!

CABINETS AND COUNTERTOPS

When thinking about changing your kitchen around, consider creating counter tops of various heights. Different tasks in the kitchen require different heights for counters. If you can’t adjust counter heights, make sure you have a stool around to make the adjustments.

To keep from getting burns or blemishes or cuts in your counter top, make sure you use cutting boards. If you do have burns or blemishes, you can hide them with a glazed tile. Just glue the tile right over the damaged area and use it as a counter top trivet.

A long slot cut into a counter top can hold knives close to where you need them, and keep space on the counter open from the clutter of a knife block.

FLOORING

You really should not use prefinished laminated or strip flooring with beveled edges. The grooves collect crumbs and other junk, plus it is harder to polish or refinish these floors.

If you need to fix a small tear in vinyl flooring, do it with a dot of tub and tile caulk in a matching color. Level the caulk and remove the excess  with a swipe of damp cloth. Your last move is to then seal the repair.

When it is time for you to wax or finish your floor, give the entire floor one good coat and then add a second coat to the high-traffic areas. Now both areas will wear in an even manner.

RECYCLING

If you feel like sparing your feet of aches and pains from stepping on cans, put together a couple of 2×4s joined together by a heavy duty hinge. Cut them to your desired length with a custom handle at the end. Now you can smash cans all day long!

ODORS

You can get rid of refrigerator and freezer odors by simply putting a cup of ground coffee in the inside of the refrigerator and leaving it over night, if the odors are still lingering, repeat the process until smells are gone.

SMART AND SAFE KITCHEN TIPS!

• If you buy expensive solid-surface counter top materials and try to install them yourself, you will probably void any manufacturer’s warranty.
• For any kitchen items you have purchased, file receipts, instructions and warranty information in a file close to the kitchen.
• when buying appliances, make sure you measure them to see if they will fit in the designated kitchen area you plan on keeping them.
• when buying counter tops, don’t accept a plastic laminate counter top if the seam is in the middle of a large work area.

Thermostats - What You Need to Know

Each year millions of people throw away money trying to heat or cool their homes.  There are a lot of great ideas and articles about making a home more energy efficient.   One idea that is rarely talked about is the Thermostat. This should be the first step in energy efficiency, since this is the tool that tells the A/C or heating unit to kick on and off. 

We met Tim from Greenspoint temp controls at a jobsite.  He saw us testing some power tools and we started talking.  Tim works mainly on commercial properties, but he says the same information he told us applies to homeowners as well.  We bought Tim a cup of coffee from the jobsite canteen truck and picked his brain a little.  Below are a couple good ideas he told us.

Occasionally, test your thermostat by using a thermometer to test the accuracy of the thermostat.  Put the thermometer next to the thermostat for about 10 minutes and compare the two readings.  If they are within 5 degrees, you thermostat is working fine.  If they are over 5 degrees apart, either the thermostat needs to be changed if electronic. If It is Mercury based, it needs to be recalibrated. 

Most people make the mistake of lowering their thermostat too much at night.  If the temp is more than a 10 degree swing, this can actually cost more money than you think you are saving.  In the morning the furnace now has to work hard in order to get the heat back up past the 10 degree mark.  Also, if the temperature outside will be close to zero or below, don’t lower the thermostat that night as this will really cause inefficiency.

Check you thermostat’s position in the room.  Even it it has been there for a while.  Maybe the installer made a mistake and didn’t install it in the correct location, or maybe something was added later that might give a false reading.  Check by your thermostat to make sure there is not a draft from somewhere.  Also, make sure there is nothing hot around the thermostat, like a TV or radio. These items can give false readings.

If you do find out that the thermostat needs to be replaced or you need to change locations, this can be done very easily.  If you need to relocate the thermostat, make sure you check the owner’s specifications on each unit.  All you will have to do is run some new wiring to the location of your choice.  This will take some time and work, but it can be done.  If you are replacing your old thermostat, this to is easy.  Most thermostats have two pieces, the head (Body) and the base.  The head is the actual unit you see on the wall with controls.  The base is the part that is screwed onto the wall.  Remember to turn off the power to that thermostat first. 

• First remove the thermostat head which is usually just snapped onto a base. 
• Second, remove the screws from the base that are attaching the base to the wall.  Now you should see four wires, Red, White, Green and Yellow, but this can vary.  Mark each wire if they are not color coded. 
• Before you remove the wires, place a piece of tape over the core of the wires to hold them against the wall, so they do not fall back behind the wall. 
• After this is secure, you can remove the wires from the base. 
• Next, place the new base in place where you want it.  Make sure it is level.  Now with a pencil, mark the spots where the screws will go.  You can drill holes for the new screws.  If you are going through drywall, just remember to use anchors when you screw the new base in place.
• Once the base is in place and the wires are attached, you can now snap the head back into place
• You can now program the new unit for your home.

Tip

If you are going to have people over, lower the thermostat temp by 5 degrees.  Bodies give off heat, so a lot of bodies around will create  good heat build up.